Installation/assembly, Assembling parts – Yamato Scientific RE550 Evaporators, Rotary User Manual
Page 12
10
Installation/Assembly
Assembling parts
6. Connecting the cooling condenser holder shaft. (glass set B & C only)
Fit the cooling condenser holder shaft firmly into the screw hole on the back of motor. Put the
attached hexagon wrench through the hole on the end of shaft and fasten tightly.
7.
Connecting the cooling condenser and condenser holder (B & C
condensers only)
1. Connect the cooling condenser to the condenser connector. Attach the cooling condenser
clamp.
2. Insert the cooling condenser holder from the top of condenser, while fitting the other side
through the holder shaft. (For type C, be sure to insert the cooling condenser holder from the
bottom of condenser rather than top and connect the condenser to the condenser connector)
3. Fit the suction cock for type B or the cooling condenser lid for type C.
Cooling Condenser Clamp
Cooling Condenser Holder
Suction Cock
Condenser Lid
- BB300 Low Constant Temperature Water Bath (64 pages)
- BBL100 Low Constant Temperature Water Bath (61 pages)
- BH200 Thermo-Elite (37 pages)
- BH400 Thermo-Elite (42 pages)
- BM100 Water Baths (16 pages)
- BM110 Water Baths (16 pages)
- BM400 Water Baths/Oil Baths (22 pages)
- BM410 Water Baths (21 pages)
- BU200 Low Constant Temperature Water Bath (18 pages)
- CLH301 Cool Line (65 pages)
- CLS301 Cool Line (55 pages)
- DC400 Freeze Dryers (33 pages)
- DG400 Drying Ovens for Laboratory Tools (41 pages)
- DKN 302 Constant Temperature Drying Oven (50 pages)
- DN410H Constant Temperature Ovens (88 pages)
- DN410I Inert Oven (88 pages)
- DNF 400 Constant Temperature Ovens (76 pages)
- DVS402 Constant Temperature Drying Oven (47 pages)
- DX302 Constant Temperature Drying Oven (40 pages)
- DX302 Constant Temperature Drying Oven (9 pages)
- HC200 Cool Block (58 pages)
- HF100 Heating Block (29 pages)
- IJ100 Low Temperature Incubator (27 pages)
- IJ201 Low Temperature Incubator (50 pages)
- K400 Shaking incubator (36 pages)
- IN603 Low Temperature Incubators (68 pages)
- IN603W Low Temperature Incubators (67 pages)
- IQ820 Low Temperature Incubators (46 pages)
- IQ821 Low Temperature Incubators (47 pages)
- LT400A Laboratory Stirrer (21 pages)
- RE200 Evaporators, Rotary (29 pages)
- RE400 Evaporators, Rotary (21 pages)
- RE210 Evaporators, Rotary (28 pages)
- RE440 Evaporators, Rotary (25 pages)
- RT200 Solvent recovery unit (15 pages)
- SN 200 Autoclave, Sterilizers (66 pages)
- Vacuum controller Vacuum controller (34 pages)
- WG201 Water Purifiers (40 pages)
- WG221 Water Purifiers (51 pages)
- WR600A AutoPure (28 pages)
- WS200 Water Purifiers (32 pages)
- External output controller type Ⅳ CR (3 pages)
- Hitech controller type Ⅳ (34 pages)