Yamato Scientific BM210 Water Baths - Manual (Page 12)

10
4. How to Operate
How to operate
1. Pour adequate water (3000ml for BM110, 5000ml for BM210) into the tank, and place a thermometer
in the holder. Use distilled water. Deionized water should not be used.
2. Connect the unit securely to a power source with AC230V. Always use a grounded outlet. Set the
temperature dial to the desired temperature and turn on the power switch. The power lamp is lit when
the power heater is on.
3. The temperature scale shows an approximate figure. When the temperature rises close to the set
point, read the thermometer to adjust the temperature. Since there are some differences from the set
point the first time, check if the current temperature accords with the degree to operate.
This unit does not have a stirring function and the tank temperature varies. We recommend you to use
any stirrer (our Lab. Stirrer etc.,) together with this unit.
Power Failure
When power supply is restored after a power failure, the unit re-starts operation from previously set
temperature.
Power Lamp
Temperature Dial