WORX WU420 400W VERSACUT Saw - Manual (Page 18)

18
Troubleshooting
Symptom Possible Causes Possible Solution
Tool will not start
when operating the
on/off switch.
Power cord not
plugged in.
Power cord is
broken.
Carbon brush has
worn down
Check to make sure
power cord is connected
well into a working outlet.
Unplug the power
cord. Replace it using a
qualified maintenance
person.
Replace the carbon
brush using a qualified
maintenance person.
Cutting depth is less
than that is set.
Sawdust
accumulated at
the rear of the
base. Shake out sawdust.
Consider connecting
a vacuum for dust
collection.
Blade spins or slips
Blade is not tightly
engaged with the
spindle.
Remove the blade,
and reassembled it as
described in INSTALL /
CHANGE THE BLADE
section.
Blade will not cut a
straight line.
Blade is dull.
Blade is not
mounted properly.
Saw is not being
guided properly. Mount a new, sharp
blade on the saw.
Check that blade is
properly mounted.
Use an edge guide.
Blade kicks back
when beginning a cut
Blade is not
spinning fast
enough Allow the saw blade to
reach full speed prior to
beginning a cut
Environmental protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authorities or retailer for recycling advice.