Function – WORX WU420 400W VERSACUT Saw User Manual

Page 15

Restore the cover (See Fig. J6).
NOTE: Pay attention that “+/-” of the batteries are the same as the
illustration on the machine.

CUTTING GUIDE (See Fig. K)
The blade alignment indicator (12) in the front of the base plate is
used as a cutting guide. Always guide it along the cutting mark made
on the workpiece for accurate cutting.
NOTE: It is best to carry out a trial cut.

Function

MAKING CROSS CUTS AND RIP CUTS (See Fig. L, M)

WARNING: To avoid sudden kick-back, never start a stationary

blade while it is in contact with the work piece.
Always start the saw and allow it to reach full speed before
commencing to plunge.
The blade teeth are exposed during this operation so proceed with
extreme caution.

a) ALWAYS use your saw with your hands positioned correctly.

WARNING: Always maintain proper control of the saw to make

sawing safer and easier. Loss of control of the saw could cause an
accident resulting in possible serious injury.
b) When making cross or rip cuts, align your line of cut with the
center of the “V” (blade alignment indicator), located on the front of
the saw’s base (See Fig. L).
c) Since the thickness of blades vary, make a trial cut in scrap material
along your cut mark to determine how much, if any, you should offset
the blade from the cut mark to allow for the blade thickness to get an
accurate cut.