WORX WU670L 250W Sonicrafter 110V - Manual (Page 12)

12
SAWING WITH THE SEMICIRCLE SAW BLADE
The workpiece must be inserted firmly or clamped tightly before it is cut.
Typical application: wood, PVC, soft metal sheet.
Select high oscillation frequency .
The saw blade lasts longer if the wear is distributed evenly. To ensure
an even distribution, loosen the saw blade, rotate it and retighten firmly.
SAWING WITH THE UNIVERSAL END CUT SAW BLADE (See E)
Warning: The sawing teeth are very sharp. Do not touch
during mounting and application.
The workpiece must be inserted firmly or clamped tightly before it is
cut.
Typical application: wood, metal (e. g. nails), plaster board and soft
plastics.
When plunging and sawing use a slight pendulum motion, to allow
sufficient chip removal.
SCRAPING
Typical application: Scraping off old varnish or adhesives, removing
glued carpeting, e. g. on stairs or other small to medium-sized
surfaces.
Select medium/high oscillation frequency.
8
9
10
E C3
D2
D1