WORX WU670L 250W Sonicrafter 110V User Manual

Page 10

Reposition the fastening piece (8) and tighten the bolt using the
supplied Allen key.

USING ADAPTERS (16) (See A3)
Accessories of other brands ( Fein

, Bosch

) can be fitted onto the

Sonicrafter

using the adapter.

Note: Fein is a registered trademark of C. & E. Fein GmbH. Bosch is
a registered trademark of Robert Bosch GmbH.
1) Use the allen key (7) to unscrew the fastening piece (8) and then

remove it from the tool holder .

2) Clean the tool holder, the adapter the application tool and the

fastening piece.

3) Fit the adapter onto the tool holder, then place the application tool

onto the adapter. Make sure that the tool holder, the adaptor, and
the application tool share a flush fit.

4) Reposition the fastening piece onto the application tool and tighten

with the Allen key.

Note: Make sure the adapter matches the application tool. The
adapter (I) is matched to the application tool of Fein

. The adapter (II)

is matched to the application tool of Bosch

.(See A3)

MOUNTING/CHANGING THE SANDING SHEET (See B1, B2)
Align the sanding sheet and press it onto the sanding pad by hand.
To ensure optimum dust extraction, pay attention that the punched
holes in the sanding sheet match with the holes in the sanding plate.
(See B2)
Firmly press the power tool with the sanding sheet against a flat
surface and briefly switch the power tool on. This provides for good
adhesion and prevents premature wear.
If one point has become worn, pull off the sanding sheet, turn it 120°