Belkin Gigabit Powerline HD Networking Adapter 8820-00111 F5D4076 - Manual (Page 7)

5
Gigabit Powerline HD Networking Adapter
sections
table of contents 1 3 4
INsTAllING AND seTTING UP THe ADAPTers
2
overview
Installation of the Gigabit Powerline HD Networking Adapter takes only
seconds and does not require setting up long wires throughout the
house . Simply plug the units directly into any available wall outlet and
connect to any device with an Ethernet port . Users have the option to
randomly change the security password for their powerline network .
Hardware setup
1. Plug your network cable into the device’s RJ45 network
adapter port .
2. Plug the other end of your network cable into the RJ45 port
located at the back of the Adapter .
3. Plug the power cable or wall adapter into the power connector
at the back of the Adapter .
4. Insert the power plug of your power cable or wall adapter directly
into a power outlet in the wall .
NoTe: Do not plug the device into a UPs or power strip with
surge protection as they may filter the powerline signal.
5. Repeat this process for the second Adapter .