Wood’s Powr-Grip LB10VLB - Manual (Page 5)

Rev 0.1/12-12 3 LB10LVB: #35206AFT
OPERATION
Operate the vacuum lifter as directed in the OPERATION section of the MRTALP lifter's instruction
manual, with the following exceptions:
WARNING: Never attempt to lift load when lifter is in horizontal
orientation.
In order to use the Vertical Lift Bar, the lifter must be attached only to loads
oriented in the upright position. Center the pad frame from left to right on the
load, and position the uppermost vacuum pad near the top edge. This position will maximize
stability while lifting the load. Make sure that all vacuum pads will fit entirely on the load’s
contact surface (see SPECIFICATIONS: Pad Spread in MRTALP lifter's instruction manual) and
that they will be loaded evenly while lifting. Then apply the lifter to the load so that the pads are
touching the contact surface.
MAINTENANCE
When performing inspections and tests of the lifter as directed in the MAINTENANCE section of
the MRTALP lifter's instruction manual, be sure to include all relevant parts of the Vertical Lift Bar
whenever applicable.
REPLACEMENT PARTS LIST
Stock No. Description Qty.
49122 End Plug - 2" x 2" x 1/4" [50.8 mm x 50.8 mm x 6.4 mm] Tubing Size 1
12822 3/8" Flat Washer 2
12756 3/8" Lock Washer 2
11120 3/8-16 Hex Nut 2
10916 Shoulder Bolt - Socket Head - 1/2" x 2 1/2" x 3/8-16 Thread 2
08093 3/4" Rubber Bumper 1
SERVICE ONLY WITH IDENTICAL REPLACEMENT PARTS
SUPPLIED BY OR APPROVED BY WOOD'S POWR-GRIP CO., INC.