Wood’s Powr-Grip CM4SL - Manual (Page 2)

Rev 1.0/3-09 APPENDIX • OPTION CM4SL #35182: 2
To Position Pads
WARNING: Make sure all vacuum hoses are coiled or routed so they do not
become entangled, kinked or punctured while operating lifter.
1) Remove the cotterless hitch pin from one sliding pad mount by
pulling on the pull ring.
2) Slide the pad mount to the desired position along the pad frame
and align the holes for the cotterless hitch pin in the pad mount
with the corresponding holes in the pad frame.
3) Secure the pad mount by pushing the cotterless hitch pin through
the holes until the retaining ball emerges on the far side of the pad mount.
4) Make sure that the vacuum hose serving the pad is not pinched, kinked, cut or abraded and
that it will not interfere with lifter operations.
5) Repeat steps #1-4 to position other pad mounts as needed. Always position pads in a
symmetrical arrangement, and make sure that all vacuum lines are functioning correctly.
I
NSPECTIONS AND
T
ESTING
When performing inspections and tests of the lifter as directed in the MAINTENANCE section of
the main instructions, be sure to include each sliding pad mount whenever applicable.
COTTERLESS HITCH PIN
1 PULL RING
2 RETAINING BALL