beautypg.com

Intended use, Haracteristics – Wood’s Powr-Grip MTCL6FS625DC User Manual

Page 13

background image

Rev 5.0/12-13

11

MTCL6FS625DC: #35078

INTENDED USE

L

OAD

C

HARACTERISTICS

WARNING: This lifter is NOT intended for lifting hazardous materials, such as

explosives or radioactive substances.

The operator must verify that the lifter is intended to handle each load, in accordance with the

following requirements:
• The load must not exceed the maximum allowable weight specified under Load Capacity (see

SPECIFICATIONS).

• The load must be a single piece of nonporous or semiporous material with a flat and relatively

smooth contact surface. Lifters equipped with foam vacuum inserts are able to accommodate
surface relief up to 3/8" [9.5 mm], provided contour changes are not too abrupt. To

determine whether the load is too porous, rough or contoured to seal adequately, perform the
test under Vacuum Level on Other Surfaces (see OPERATION: T

O

A

PPLY THE

P

ADS TO A

L

OAD

).

• The load's contact surface must be suitable for obtaining a friction coefficient of 1 with the

lifter's vacuum pads (see MAINTENANCE: V

ACUUM

P

AD

M

AINTENANCE

: Friction Coefficient), as

verified by a friction test. If necessary, contact Wood's Powr-Grip for help in conducting a
friction test.

• In order to avoid damaging the vacuum pads, the load's surface temperature must not

substantially exceed the allowable Operating Temperatures (see SPECIFICATIONS).
However, if such an application cannot be avoided, contact Wood’s Powr-Grip or an

authorized dealer about solutions which may enable you to lift loads with higher surface
temperatures.

• While the

minimum

length and width of the load are determined by the Pad Spread (see

SPECIFICATIONS), the

maximum

length and width are determined by the allowable

overhang, or the amount of load material that can extend sideways beyond the vacuum pads
without breaking or otherwise being damaged.
The allowable overhang depends on the kind of load material being lifted, the thickness of the

material, and the angle at which it is handled (if any). Since materials such as glass, stone or
sheet metal each have different physical properties, the allowable overhang must be

evaluated separately for each type of load. If necessary, contact Wood’s Powr-Grip or an
authorized dealer for help in determining the recommended overhang in a specific situation.

• 8" [20 cm] is the maximum allowable thickness of loads at the maximum weight (see

SPECIFICATIONS: Load Capacity). However, allowable thickness increases as load weight

decreases. If necessary, contact Wood’s Powr-Grip for help in determining the maximum
thickness permitted when handling any specific load.

Note: Vacuum pads can stain or deform load surfaces with light colors or soft coatings. The

operator should test such surfaces for detrimental effects before using the lifter on them.