Wood’s Powr-Grip CF15CEO - Manual (Page 11)

Rev 0.0/11-11 9 CF-CEO: #35186AFT
arrange the vacuum pads in a symmetrical configuration about the MRTALP-DC's main pad
frame, in both width and length dimensions. To prevent lifter damage when the extension kit or
rocker arms are used, always use the lift spool assembly and slings regardless of the
configuration selected.
After changing the pad frame configuration, make sure all vacuum hoses are secure and routed
to avoid being pinched, snagged, abraded or otherwise damaged while the lifter is in operation.
Also be sure to verify that all pads are connected and functioning correctly (see preceding
discussion).
PAD SPREAD AND MAXIMUM LOAD CAPACITY
Configurations are shown with the following optional components and VPFS625 vacuum pads installed
(from top to bottom):
a) 1 set of T-Arm Assemblies
b) Extension Kit (2 arms in use) and 1 set of T-Arm Assemblies
c) Extension Kit (2 arms in use), Rocker Arms, and 2 sets of T-Arm Assemblies
d) Extension Kit (4 arms in use) and 1 set of T-Arm Assemblies
e) Extension Kit (4 arms in use), Rocker Arms, and 2 sets of T-Arm Assemblies