Western Digital My Book World Edition II (blue rings) Quick Install Guide - Manual (Page 4)

My Book World Edition | 3
Power Button
The power button turns the device on or off. To turn on the device, press the power button and hold down until
the LED flashes once, then release. The LEDs will remain off (up to 30 seconds) as the device powers up.
Holding the button down for four seconds powers off the device.
WD Anywhere Access ™ Setup
This section contains instructions to get your My Book World Edition quickly set up and running. To use
My Book World Edition, installation of WD Anywhere Access is required. A software license key is not needed
to install WD Anywhere Access.
Note: WD Anywhere Access is a custom version of MioNet. If the regular version of MioNet is already installed
in your system, you must uninstall it before installing WD Anywhere Access.
1. Insert the software CD into your CD-ROM drive. The program autoruns and displays the My Book World
Edition main menu. In Step 1, click Install.
If AutoPlay is disabled on your computer, you must install utilities manually. Click the Start button and point
to My Computer. Double-click the WD Installer icon, the WDAnywhereAccess folder, and Setup.exe.
2. Read the license agreement. Click the I agree with the above terms and conditions check box,
then click Next.
3. Click Finish. WD Anywhere Access (powered by MioNet) is initialized.
4. The WD Anywhere Access Registration Wizard starts. Click I am creating my new WD Anywhere
Access account if new to MioNet, then click Next. If adding the computer to your existing account, click
I am adding this computer to my existing WD Anywhere Access account, enter your user name and
password in the next screen, click Next, and proceed to step 6.
Important: The device powers on automatically upon initial connection to power, which may take
up to three minutes. During this time, do not press the power button.