WarmlyYours JSR00 - Manual (Page 2)

Assembly Tools Needed
• Utility knife
• Wire cutter
• Needle-nose pliers
• Adjustable wrench
• Pen
• Screwdriver
• Heat gun
• Measuring tape
General Safety Information
Read and understand all instructions in this manual, including all installation instructions and safety warnings, before beginning
the installation. Electrical cables can present a fi re, shock, and arcing hazard if they are damaged or not installed correctly.
1. Installation must be in compliance with the National Electrical Code (NEC).
2. Use 30-mA ground-fault protection on each heating cable branch circuit for maximum protection.
3. The black heating cable core is conductive and can short. It must be properly insulated and kept dry.
4. The conductive layer of this heating device must have a suitable grounding terminal.
5. Installer should apply the nameplate label to surface of the junction box.
6. Keep components and ends of heating cable dry before installation.
7. Do not break braid or bus wire strands when scoring the jacket or core. Damaged bus wires can overheat or short.
8. Keep the bus wires separated. The bus wires will short if they touch each other.
9. Replace damaged parts. Heat-damaged components can short.
10. Use heat gun or torch with a soft yellow, low-heat fl ame--not a blue fl ame. Keep the fl ame moving to prevent overheating or
blistering the heat-shrinkable tubes.
11. Do not heat other components.
12. Use only fi re-resistant insulation materials such as fi berglass wrap.
13. De-energize all circuits before installation or service.
14. The heating cable should not be embedded in insulation or roofi ng material.
15. Do not twist cable during installation.
16. Save all instructions for future reference.
CAUTION: Charring or burning the heat-shrinkable tubes in this kit will produce fumes that may cause eye, skin, nose, and throat
irritation.
ET-PWR-END-KIT Installation Instructions ET-PWR-END-KIT
1