Waring Pro WC400 - Manual (Page 6)

6
will turn in a counterclockwise direction and enter the cork,
then gradually remove it from the bottle. When the electric
mechanism has stopped, the cork has been fully removed
from the bottle.
3. Lift the wine opener up and away from the bottle. To remove
the cork, press the upper part of the switch as indicated by
the up arrow. The spiral will turn in a clockwise direction and
release the cork.
4. Always return the wine opener to the charging base when
done. This will protect the unit while it is not in use.
TO OPERATE YOUR WINE PRESERVER
1. Place the wine bottle on a flat surface.
2. Insert the wine stopper into the wine
bottle.
3. Hold the wine stopper and wine bottle
neck securely in one hand and place the
non-slip foot of the wine preserver on the
wine stopper.
4. Keep the wine preserver as straight as
possible and in line with the wine bottle.
5. Push down on the wine stopper and
press the power button at the same time.
6. The wine preserver begins to work,
removing the air from the bottle while
making a clacking noise.
7. The clacking noise will become slower
and stop suddenly after approximately
20 seconds.
8. Do not release the power button until the unit stops.
9. Remove the wine preserver and replace on its stand in the
upright position until it is needed again.
10. Always return the wine preserver to the charging base when
done to protect it while not in use.
11. After sealing the wine bottle, store bottle in the upright
position as wine may leak if its on its side.