Waldmann PULSE PIR version IV - without MFT - Manual (Page 8)

8
Operating manual Light Control „PULSE PIR - Vers. IV“ ENG
Change basic settings - Part 1
Fig. 2
LED II
Key II
LED I
Key I
Sensor
Change to
parameterisation mode
Keep both switches [I and II]
pressed simultaneously for 10
seconds.
- The operating panel changes to
the parameterisation mode (first
to setting level 1).
- LED II flashes in the respective
colour according to the level:
white: level 1
red: level 2
green: level 3
blue: level 4
Change setting level
If both keys [I and II] are pressed
repeatedly within 5 seconds, the
next level is called.
- Level 2 is reached when LED II
flashes red.
- Level 3 is reached when LED II
flashes green.
- Level 4 is reached when LED II
flashes blue.
Change function
When the desired setting level is
reached, the setting of the first
function (x.1) is displayed on the
light bar (LED I is lit or LED flashing
green).
By pressing key II, it is now possib-
le to switch between functions.
- LED I flashes in the respective
colour according to the function:
green: Function x.1
red: Function x.2
blue: Function x.3
turquoise: Function x.4
magenta: Function x.5
orange: Function x.6
white: Function x.7