Waldmann PULSE PIR version IV - without MFT - Manual (Page 10)

10
Operating manual Light Control „PULSE PIR - Vers. IV“ ENG
List of functions
The following functions can be selected:
The bold-printed values are the in-factory defaults
Level Function LED II LED I Designation
1 Function 1.1: flashing white green Background light ON/OFF
1 Function 1.2: flashing white red External activation ON/OFF
1 Function 1.3: flashing white blue Burn-In function ON/OFF
1 Function 1.4: flashing white turquoise Write protection ON/OFF
1 Function 1.5: flashing white magenta Light control ON/OFF
1 Function 1.6: flashing white orange presence control ON/OFF
1 Function 1.7: flashing white white Demo mode ON/OFF
2 Function 2.1: flashing red green Sensitivity high ON/OFF
2 Function 2.2: flashing red red Switch-on automatic ON/OFF
2 Function 2.3: flashing red blue Dual sensors ON/OFF
2 Function 2.4: flashing red turquoise Sensor LED ON/OFF
2 Function 2.5: flashing red magenta Continuous operation ON/OFF
2 Function 2.6: flashing red orange Parameter setting protection ON/OFF
2 Function 2.7: flashing red white Special function ON/OFF
3 Function 3.1-3.6: flashing green green ... orange Follow-up time 5, 10, 15,20, 25, 30 min
4 Function 4.1-4.6: flashing blue green ... orange Range 10, 20, 40 ,60, 80, 100 %
Note: The functions written in blue are not available. Please observe the explanations of the functions on
the following pages.
Fig. 2
LED II
Key II
LED I
Key I
Sensor