Bushnell 26-0400 User Manual

Page 4

GETTING STARTED

Installing Batteries

This device operates on two AA batteries. To install, unscrew the

battery compartment cover located on the bottom of the unit. Insert the

batteries into the battery compartment so that the (+) and negative (-)

terminals of the batteries match the markings inside the compartment.

Replace the battery cover carefully – do not over tighten.

Use and Testing

This device operates on two AA batteries. Make sure they have been

installed according to the instructions above.

If you wish to test your night vision device in a lighted area, be sure

the objective lens cap is covering the objective lens prior to pressing

the “POWER” button. The objective lens cap has a pinhole opening

to admit a small amount of light for testing purposes.

If testing or using the device in the dark, remove the objective lens cap

and activate the device by pushing the “ON” button.

To focus, select an object at the approximate distance for the area

that you intend to view. Set the adjusting mark on top of the front

(objective) lenses against the letter “N” on the word “Normal”. Adjust

each eyepiece diopter setting until the image is in focus. After your

initial diopter setting, the front (objective) lenses are now utilized for

focusing: adjust the front lenses clockwise when you need to focus on

closer objects, counter clockwise for more distant objects. If you are

unable to focus on very close objects, the eyepieces may then be used

for micro adjustments only.

Your Night Vision device offers a Built-In Infrared Illuminator.

This allows you to see in complete darkness where no

ambient light source, such as moonlight, is available. If the

subject is to be viewed in a completely dark area, activate

the infrared illuminator by pressing the Infrared Illuminator

button located next to the “POWER” button. This device can

be mounted on any tripod with a 1/4“ tripod socket.