Vortex Optics SPITFIRE 3X PRISM SCOPE User Manual

Page 3

onTrolS

and

djuSTmenTS

Battery Installation

Remove the battery compartment cover using a coin
or screwdriver. Install and orient the CR 2032 battery
so the positive side (+) faces upward, then replace the
cover. When replacing the cover, be sure it is fully
screwed down with the o-ring seal in place.

Illumination Control

The reticle can be used without illumination. To
activate the reticle illumination, rotate the illumination dial to the left or
right. The dial shows both red and green numbers, indicating five levels of
brightness. Rotate the dial so the number indicating the desired color and
intensity faces the shooter.

Note: Be sure to turn the dial
to zero when done shooting to
avoid running the battery down
prematurely.

Rotate dial to
set the preferred
color and intensity.

riSm

cope

djuSTmenTS

Reticle Focus

This Vortex Spitfire prism scope uses a fast focus eyepiece designed to
quickly and easily provide a sharply focused
reticle.

To adjust the reticle focus:

• Look through the scope at a blank white
wall or up at the sky.

• Turn the eyepiece focus dial in or out until
the reticle image is as crisp as possible.

• Note: Try to make this particular
adjustment quickly, as the eye will try to compensate for an out-of-
focus reticle.

Once this adjustment is complete, it will not be necessary to re-focus
every time you use the scope. However, because your eyesight may
change over time, you should re-check this adjustment periodically.

Warning

Looking directly at the sun through a scope, or any optical instrument,
can cause severe and permanent damage to your eyesight.

Adjust the reticle focus.