Vortex Optics RAZOR HD GEN II 1-6X24 RIFLESCOPE — VMR-2 Reticle - Manual (Page 5)

9 8
RIFLESCOP
8 9
R
iflescope
m
ounting
To get the best performance from your Vortex Razor HD Gen II
riflescope, proper mounting is essential. Although not difficult,
the correct steps must be followed. If you are unsure of your
abilities, it would be best to use the services of a qualified gunsmith.
Centering the Reticle
The Razor HD 1–6x24 riflescope is pre-set from the factory
with the reticle in the center of the adjustment ranges. If you
have changed the settings and wish to reset the reticle to the
center, this can be done easily:
1. Turn the dial (windage or elevation) fully in either direction
until stopped. Do not force the dial—as soon as any resistance is felt,
stop turning.
2. Carefully counting the dial rotations, turn the dial in the other
direction until stopped. Again, stop turning as soon as resistance is felt.
3. Turn the dial back again half the amount of rotations counted
and that adjustment will be centered.
Rings and Bases
Following the manufacturer’s instructions, mount high quality base
and rings to your firearm. The Razor HD 1–6x24 riflescope requires
30 mm rings.
Ring height for Razor HD 1–6x24 riflescopes will depend on
the firearm and mount being used. Consult the ring and base
manufacturer for suggested heights.
After this procedure is completed for both the windage and
elevation dials, the reticle will be approximately centered.
AR-style rifles will usually require an extra-high mounting height
on a specialized cantilever-style mount such as the Vortex ADR-X
cantilever ring mount (shown above).