beautypg.com

Vigo VG06063 User Manual

Page 12

background image

MODEL VG06063

12

FIG.11

9

12

14

H. INSTALLING THE WATER SEAL STRIPS

1.

Clean the door glass panels (#12) edges where the door magnetic seal strips (#9) and the
door bottom seal strips (#14) are to be installed with rubbing alcohol.

2.

Cut the seal strips according to the diagram. [SEE FIG.11] They are pre-cut already but you
may have to cut more to have it fit properly as displayed in the diagram.

3.

Verify that the lips of all seal strips face toward the inside of the shower cabin before seal strip

installation.

4.

Install the seal strips according to the diagram.

THIS SIDE MUST

LOOK INSIDE

THE CABIN

14

13

12

12

9

14

HINGE SIDE

HANDLE SIDE

MAKE SURE TO
MEET THE
BOTTOM OF THE
GLASS

14

NOTES:
1. If the seal strip is not flat and is twisted, soak the strip in hot water and press the seal strip back
into position.
2. Cutting/finishing is needed but only after fully installing and only at the top of the unit.