Vigo VG06063 User Manual
Page 10
VIEW FROM INSIDE
FIG.8
HEX SCREW
SIDE
GLASS PANEL (4)
DOOR (12)
THIN
GASKETS
VIEW FROM THE TOP
HINGE (7)
OUTSIDE OF
THE CABIN
INSIDE OF
THE CABIN
PLATE
10
MODEL VG06063
WARNING
!
DOOR PANEL INSTALLATION REQUIRES TWO OR MORE PEOPLE TO ASSIST
E. INSTALLING THE DOOR
1.
Clean the door (#12) glass surfaces where the hinges (#7) are to be installed with rubbing
alcohol.
2.
Do not install the handle first, this is dangerous and may cause the glass to break. Install the
top hinge first for safety and ease of install.
3.
Position the door onto the hinges. Place a thin gasket (supplied) on each side of the door
between the glass and hinge while holding the door in place. Hold securely in place using
shims. The seal (#13) may get stuck between the two panels of glass. Pull the seal out of the
groove using your fingers and nothing sharp, making sure not to damage the seal. Tighten
allen key screws.
4.
Install the hinges as illustrated. [SEE FIG.8] Use the hex key supplied.
5.
Adjust hinge so the gaps are equal at top and bottom and pull door panel away from side
panel to allow the door to swing freely without crimping seal strip (#13).
6.
Lift door panel to be level with hinge panel. Use PVC shims provided to hold firmly in place.
7.
Repeat steps 1 through 6 to attach the hinges to the other door.
NOTE - You may need to add more than one shim per hinge as glass hole openings vary during
production. PVC shims prevent the door from sagging due to gravity and the
weight of the door. Never install without shims, this can cause the glass to break causing
property damage and bodily harm.
!