Vigo VG06061 - Manual (Page 14)

I. APPLYING THE SILICONE
1. Apply clear silicone caulking to the inside between the wall and side seal strip.
2. Apply clear silicone caulk to the inside between the bottom of side glass panels (#4, #5) and
bottom rail.
3. Apply clear silicone caulk around the inside perimeter of the bottom rail. [SEE FIG.13]
4. Apply clear silicone caulk to the seal strip connections of the door bottom seal strip and the door
magnetic seal strip. [SEE FIG.13A]
H. INSTALLING PRE-CUT BOTTOM DOOR SEAL STRIP
1. Clean the door glass panel (#13) edge where the door bottom side seal strip (#15) is to be installed with
rubbing alcohol.
2. [SEE FIG.12]
3. Verify that the soft flange of the seal strip faces toward the inside of the shower cabin before seal strip
installation.
4. Install the seal strip according to the diagram.
NOTE: If the seal strip is not flat or twisted, use hot water and a hair dryer to apply minimal heat and press the seal
strip back into position.
13
10
15
13
10
FIG.12
13
OUTSIDE OF
THE CABIN INSIDE OF
THE CABIN
10
15
15
14
MODEL VG06061