Vigo VG06061 User Manual

Page 12

F. INSTALLING SIDE GLASS PANEL (PART #5)

Install the side seal strip (#6) to the wall side of the side glass panel (#5). Install the magnetic

side seal strip (#10) to the door side.

The magnetic side should be facing the outside and

the clear side be facing the inside. Be sure to place the seal strip (#6) 10mm from the

bottom of the glass. [SEE FIG.9] Installing the magnetic seal strip prior to locating the place

for the glass support allows for proper seal. You may need to adjust the magnetic seal strip

placement after full install to guarantee proper placement on the top of the corner joint. It

should rest tight on the corner joint in order to prevent water leakage.

Screw in the glass support (#7) to the side glass panel using the hex key (supplied) making
sure to slide it back as far as possible from the glass before you tighten. Be sure to use

washers on both sides of the panel.

Place the side glass panel into the bottom rail (#9). Use the level to position the side glass
panel correctly. Making sure the seal strip is against the wall.

4. Mark holes on the wall for the mounting screws.

5. Remove the side glass panel. Drill holes into respective marks and insert plastic anchors

(#20) inside them. Not necessary if installing into studs. Studs are the preferred means of
installation, anchors can pull out of the wall causing property damage and bodily harm.

6. Replace the front glass panel back onto the bottom rail and screw it to the wall with 1 5/8"

screws (#17).

FIG.9

THIN

GASKETS

WALL

SIDE

DOOR

SIDE

GLASS SUPPORT (7)

GASKET

SIDE GLASS PANEL (5)

HEX SCREW

VIEW FROM THE TOP

WALL

FIG.10

HEX SCREW (17)

3/8"

[10mm]

MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM

THE BOTTOM OF
THE GLASS

MODEL VG06061