Bogen DST1 - Manual (Page 8)

To Select a Band*
Press the button marked AM/FM. The current band selected (either AM or
FM) appears on the display.
You can preset up to 60 stations total for both bands. Preset stations may be
any combination of AM and FM stations. FM stations may be played in either
stereo or mono. Press the STEREO/MONO button to change mode.
To Tune a Station*
Pressing the TUNING + or TUNING - button advances to the next fre-
quency. Pressing and holding the TUNING + or TUNING - button will ac-
tivate the auto search feature. The word
AUTO
appears on the display, and the
search will continue to the next clear station signal. To stop the auto search
at any frequency, press either the TUNING + or TUNING - button again.
To Preset Stations*
1. Select a band and tune the first desired station.
2. Press the MEMORY button and then one of the CHANNEL +/- buttons
to select the preset number. The two-digit preset number appears on the
display. The display flashes twice and then the preset is stored.
3. Repeat the procedure for each desired preset.
To Scan Preset Stations*
1. Press the button marked INTRO. Each preset station will play for a few
seconds in turn while scanning.
2. To select a station during scanning, press the INTRO button again.
To Select Preset Stations Using Remote Control
The number buttons can be used to select a specific preset station. For
presets greater than 10, press
10+ for each multiple of 10 (for example, 10,
20, 30, etc.), then select the preset in that multiple.
Example: To select preset 52, press
10+ five times, then press 2.
Pressing P.CALL allows actual station numbers to be entered.
1. Select a band.
2. Press the P.CALL button.
3. Enter the Station numbers.
* Note: These functions are the same whether accessed from the front
panel of the DST1 or from the Remote Control.
8