Vigo VG06021 - Manual (Page 8)

8
MODEL VG06021
FIG.7
11
12
13
12
THIS SIDE MUST
LOOK INSIDE
THE CABIN
THIS SIDE MUST
LOOK INSIDE
THE CABIN
D. INSTALLING THE DOOR SIDE SEAL STRIPS
1. Clean the door glass panels (#11) edges where the door side seal strips (#12) are to be
installed with rubbing alcohol.
2. Place the seal strips according to the diagram. [SEE FIG.7]
3. Verify that the lips of all seal strips face toward the inside of the shower cabin before seal strip
installation.
12
MAKE SURE TO
MEET THE
BOTTOM OF THE
GLASS
MAKE SURE TO
MEET THE
BOTTOM OF THE
GLASS
NOTES:
1. If the seal strip is not flat and is twisted, soak the strip in hot water and press the seal strip back
into position.
2. Cutting/finishing is needed but only after fully installing and only at the top of the unit.