Vararam Hemi Ram-AIR - Manual (Page 3)

Clip the harness clamps in the central firewall area to allow the wiring loom some slack
Remove factory orange seal around throttle body.
Install supplied bracket ,by loosening A/C bolt, you only need to back this out 1/4 inch,
slide in bracket and tighten bracket.
( Prepare hemi under glass for install by, attaching supplied red hose onto rear air horn, slide on one
clamp and tighten this completely to the air horn,slide a second clamp on but "DO not tighten yet" )
Install the kit at a 45 deg angle sliding the hose onto the throttle body as U lower the kit into place.