3 easy steps – Undercover Hidden Hinge Version User Manual

Page 4

PAGE 4

Removal, Reinstallation & Wall Hanging Instructions

Minute

Removal

Minute

Re-Install

3 Easy Steps!

Wall Hanging Instructions

Step 1 - Release strut off of ball stud, be sure to

secure cover to prevent it from closing unex-

pectedly. Place loose end of strut in storage

clip. Repeat for other side.

Step 2 - Turn twist knobs until they release.

Step 3 - Pull tonneau cover rearward, releasing

hinge from mounting bracket, and lift the

cover off.

Step 1 - Place tonneau cover on the truck. Slide

the slots in the 4 bar hinges (attached to the

cover) over the posts on the front mounting

brackets.

Step 2 - Push the cover forward to lock the

hinges to the mounting brackets. Lift the cover

up from the rear and tighten the twist knobs

on both left and right hinges.

Step 3 - Re-install the struts.

Step 1 - Prior to removing the tonneau, mount

the two J-Hooks provided, on the garage wall.

The hooks must have a minimum height from

the floor of 84”. Center horizontally 32“ apart

from each other.

For long bed trucks mount 98” from floor.

Step 2 - Remove your tonneau from the truck

bed.

Step 3 - Hang the tonneau vertically on the

hooks, under side against the wall, inserting

the hooks into the holes provided.

Twist Knob

HYDRAULIC STRUT

(LARGE END)

ATTACHES TO COVER

(ROD END)

INCORRECT

PLACEMENT

OF FRONT FLAP

UnderCover, Inc.

P.O. Box 620

Rogersville, MO 65742