TaoTronics TT-BS008 - Manual (Page 3)

3
Using The Setup Mode To Configure The Decoder
The decoder can be configured through the use of the computer keyboard . The decoder must be
installed and powered to enter the setup mode Once the unit is powered up press and hold the
following keys :
Left-Control ,Caps Lock, Right-Shift ,and Backspace
1
-or-
Left-Control,F2,Right-Shift,and Backspace
2
Once you release the keys , the decoder will produce a series of beeps , change the LED to orange and display a message
similar
to the following on your display :
F1-F10=Options，Use ARROW KEYS to Toggle/Move ,ESC=Exit
To ensure that you have enough space on your command line for the decoder options to be displayed we
Reconnend that you either have your command prompt located at the root directory or that you load an editor
with a new file. This will allow the decoder to use most of the characters on your computer display For
example,in Windows load Windows Write and in OS/2 load the Notepad program
Note : In addition to suing your keyboard to enter Setup Mode you may scan the bar code below
Enter Setup Mode
Note: This page is onlyfor KBW interface reader , never execute any action if you are using RS232 interface
reader