Sealed burners, Burner caps, Burner grates – Bosch NGT User Manual
Page 8
English 4
Sealed Burners
Your new cooktop has sealed gas burners. There are no burner parts under the
cooktop to clean, disassemble or adjust. Your cooktop has two different burner
cap sizes, large and medium. Match the pan to the size burner.
Burner Caps
The burner cap is porcelainized steel. On the underside of the cap is one locator
which must fit into the corresponding notch on the burner base. If the burner cap
is not placed correctly, the burner may not light or the flame may not burn com-
pletely or correctly.
Figure 2 - Burner Cap
WARNING:
To prevent flare-ups do not use the cooktop without all
burner caps and all burner grates properly positioned.
Burner Grates
The position of each double grate is labeled on the underside edge of the grate as
shown in the figure below.
Figure 3 - Burner Grates
30" (76cm) Models have two universal grates. Position the straight side in the cen-
ter. They are interchangeable by rotating 180°.
36" (91cm) Models have one side grate, one center grate and one single grate.
Position the grates on the cooktop as illustrated above.
BURNER BASE
Igniter
Locator
Ports
Porcelain
Enamel Cap
BURNER CAP
Notch
Universal -
30” models
only
Side
Center
Single -
36” models
only