Mounting the jetpack – Switronix Jetpack X User Manual

Page 2

Mounting the Jetpack:

1/4-20 Option: RED DSMC users can purchase a Wooden Camera Quick Back and attach it to the back of the Jetpack X. This provides
a simple, elegant mounting platform on the back of your RED Scarlet/EPIC. The JPX’s aluminum case has three 1/4-20

threads mounts on the bottom for mounting it vertical. You can also utilize the

cheesplate for additional mount points. Screw hardware is included to attach the

cheeseplate to the rear of the Jetpack X.

X-MT Plate Option: The Jetpack X will mount to any camera or
rail mount plate which has standard V-mt or 3-Stud hole patterns
with the included X-MT plate. Once you attach the X-MT plate to
your device or plate backing, align the 4 posts of the X-MT plate
to the back of the JPX, and push downward until the 1/4-20
thumbscrew on the JPX is aligned with the X-MT plate. Thereafter screw the thumbscrew clockwise
to tie down the JPX to the X-MT Plate.

ENG Camera Option(Panasonic, JVC, AJA CION): After mounting
the X-MT plate to the rear of the ENG Camera,
connect the 2-pin AMP connector to the camera and then align
and tie-down JPX(as stated in X-MT Option).

RECON X5 Daisy Chain Mounting: The RECON X5 wireless Transmitter works

with the X-MT system. Mount the modular Recon X5 to the camera via the X-MT

plate option, then attach an additional X-MT Plate directly to the front of the

Recon X5 module. Connect the AMP power connection together prior to

aligning and tie down of the JPX.

JetPack X Pin-Outs

JPX-V-EPIC/JPX-A-EPIC

REPRESENTATION FROM REAR VIEW OF CONNECTOR

Switronix is not responsible for any improper wiring should a user choose to produce their own mating cables. TRIPLE CHECK polarity prior to
connecting the JETPACK to any devices when using your own cables. If you have ANY DOUBT, we offer all the cables through our distribution
base, as well as custom cables should you need.

Any questions, call 800-613-7948 or email [email protected]

____

LEMO PART #
FGG.0B.304.CLAD52Z

LEMO PART #
FGG.0B.302.CLAD52Z

LEMO PART #
FGG.0B.304.CLAD52Z

12v

KEY**

____

JPX-V-BMCC/JPX-A-BMCC/JPX-V-XLR/JPX-A-XLR/JPX-V-BASE/JPX-A-BASE

__ __

____

LEMO PART #
FGG.0B.303.CLAD52Z

LEMO PART #
FGG.0B.304.CLAD52Z

LEMO PART #
FGG.0B.302.CLAD52Z

12v

7.2v

KEY**

____

Switronix, Inc.

Tel: 1-800-613-7948, 516-750-9675

87 Garden Street

Fax: 516-594-1414

Westbury, NY 11590 Web site: http://www.switronix.com

For 2B LEMO

POWER INPUT

Wire connector as

follows for JPX to

charge!!