Summit SEH2624 - Manual (Page 11)

10
E F
wood wall
Chimney Mounting
Plate
Ш10
Ш10
wood wall
INSTALLING THE RANGE HOOD ON THE
WALL
1. Bore the suspender holes:
Use the assembly template to bore
holes. Using a Ø 10mm drill bit, drill 4
holes A, B, C, D into the wall. With the
same drill bit, drill 2 holes (E, F) to screw
on the chimney mounting plate. Drill
holes must be about 9/16" (15 mm)
below the ceiling.
2. Fix the inserts:
Fix 4 inserts of Ø 10mm into the holes A,
B, C and D.
Fix 2 inserts of Ø 10mm into the holes E
and F.
3.Fix the suspender screws.
Fix the screws to holes A and B.Keep a clearance of 5
mm (0.2") between wall and head of screws in order to
hang the hood body easily.Fix the chimney mounting
plate to holes E and F by using the screws provided with
hood.
13
CLEANING AND MAINTENANCE
*
Disconnect the device prior to maintenance (cut off its power supply by turning off
the switch).
* The aluminum cassette filter holds oils and dust from the air. The metal filter must
be washed in hot soapy water every month, if possible in the dishwasher at
140°F.
* To disassemble, press on the spring clamps at the edge of the cassette filter.
(Do not reassemble before drying after cleaning.)
* Outer surfaces of the hood should be wiped with a cloth dampened with a solution
of liquid detergent. Do not clean the unit with products containing corrosive
substances.
* Avoid wetting switches or other electronic parts when cleaning with water or
other liquids.
* When cleaning stainless steel surfaces, use products specifically made for this
use.
Note: Aluminum filters may change color after several washings in the dishwasher.
This is normal and does not affect the performance of the filter.
CARBON FILTER REPLACEMENT
Before replacing the round carbon filters, disconnect the power to your device. The
carbon filters are located behind the metal filter, on the left and the right sides of the
blower. First, take out the metal filter. To replace the carbon filters, remove the old
ones from the device and mount the new ones as shown. In kitchens that do not
have a chimney outlet, the carbon filter should be replaced every 3-5 months
depending on usage.