Summit SCR1005 - Manual (Page 9)

 The temperature you are setting will increase by one degree each time you touch the UP
symbol, and will decrease by one degree each time you touch the DOWN symbol.
 The range of the temperature control is from 34°F to 43°F.
 To view the set temperature at any time, touch the UP or DOWN symbol. The set temperature
will flash in the display window for 5 seconds. After 5 seconds, the temperature inside the unit
will reappear in blue in the display window.
NOTE:
 If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
 When you use the unit for the first time or restart the unit after it has been shut off for a long
time, there could be a few degrees variation between the temperature you select and the one
indicated on the LED readout. This is normal and is due to the length of the activation time.
There should not be a problem once the unit has been running for a few hours.
Interior Light
The unit is equipped with an interior LED light which can be turned ON or OFF by touching the
symbol.
DOOR LOCK
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the Instruction Manual. Insert the key into the
lock and turn it counterclockwise to unlock the door. To lock the door, do the reverse operation, making
sure the metal pin is engaged completely. Remove the key and put it in a secure place for safekeeping.
SHELVES
To prevent damaging the door gasket, make sure to have the door all the way open when pulling the
shelves out of the rail compartment.
 For easy access to the stored content, you can pull
the shelf approximately halfway out of the rail
compartment. However this unit was designed with
a plastic post on each side of the shelf track to
prevent shelf contents from falling.
 When removing the shelf from the inner rails, make
sure to remove all shelf contents first. Then move
the shelf to the position where the notches in the
shelf are exactly aligned with the plastic posts and
lift the shelf. In order to replace the shelf, repeat
this procedure in reverse.
9