Operating your appliance – Summit SWC1545 User Manual
Page 7
INSTALLING THE STAINLESS STEEL HANDLE
This wine cellar includes a stainless steel handle that is not required to operate the unit. To install the
handle (if not already installed), follow the instructions below:
1. Pull away the door gasket in the area where
the handle is to be installed. The gasket is
easily displaced by hand; no tools are
necessary.
2. Using a flathead screwdriver, remove the two
(2) pre-installed decorative plugs from the
back of the door. Save the decorative plugs
for future use.
3. Insert the two (2) Phillips head handle screws
with the lock washers and flat washers
through the gasket side of the door frame until
the screws pass through the door frame.
Follow the sequence shown in the figure.
4. Align the handle with the screws installed in step # 3 above. Tighten the screws using a Phillips
head screwdriver until the handle is both flush and secured tightly against the door frame. (DO
NOT over-tighten as this will cause damage to the handle assembly.)
5. Replace the door gasket to its original position.
Handle
Door Frame
Gasket
Screw
Lock Washer
Flat Washer
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between 72º and
78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate. The range of 40º-72ºF (5º-22ºC) may not be reached.
NOTE:
If the unit is unplugged, or power is lost or turned off, you must wait at least 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the unit will not start.
The SWC1545 defrosts itself automatically.
RECOMMENDED TEMPERATURE SETTINGS
Conservation
49 ~ 57ºF
10 ~ 14ºC
Red Wines
58 ~ 72ºF
15 ~ 22ºC
Dry/White Wines
48 ~ 57ºF
9 ~ 14ºC
Rosé Wines
49 ~ 51ºF
10 ~ 11ºC
Sparkling Wines
40 ~ 47ºF
5 ~ 8ºC
7