Summit SWC525LBI - Manual (Page 7)

6
Reversing the Door Swing:
Figure 1 (Default position) Figure 2 (After door reversal)
1. Upper hinge cover 6. Screws
2. Screws 7. Hole cover
3. Upper hinge 8. Cabinet
4. Door 9. Pin cap
5. Lower door hinge
This wine cellar can be opened from either the right side or the left. By default, the
door hinge is on the right side. If you prefer it on the left, please follow these
instructions:
NOTE: All of the parts that are removed must be kept for the reinstallation of the
door.
1. Remove the upper hinge cover (1).
2. Remove the three screws (2) that hold the upper door hinge (3).
3. Lift the door and place it on a padded surface to prevent scratching.
4. Remove the three screws (6) that hold the lower door hinge (5).
5. Remove the hole cover (7) and transfer it to the same location on the opposite
side.
6. Insert the lower door hinge (5) into the left side, fixing the hinge into place by
tightening all the screws (6).
7. Remove the pin cap (9) from the left side of the upper door frame and then
transfer it to the same location on the opposite side.
8. Set the door on the lower door hinge (5), keep the door level, then fix the upper
hinge (3) to the body (8) with the screws (2).
9. Put on the upper hinge cover (1).