Summit STC1B3 - Manual (Page 5)

Installation Instructions
Before using the Buffet Chiller:

Remove the exterior and interior packing.

Clean the interior of the unit as described on page 5.

Place your appliance on a surface that is strong enough to support it when it is fully
loaded. Be sure the plastic frame is in place and that the unit is level.

Position the unit away from direct sunlight and sources of heat (oven, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold or hot ambient temperatures may also cause the
appliance to perform improperly.

This Buffet Chiller is not designed for placement in a garage or basement. It is
designed for indoor use.
STC1B3 shown with
optional lid and two pans
(not supplied)
Electrical Connection
 WARNING 
Improper use of the grounding plug can result in the risk of electrical
shock. If the power cord is damaged, have it replaced by an
authorized service center.
This unit requires a standard 110V-60HZ electrical outlet with 3-pin plug.
The unit should be properly grounded for your safety. The power cord is equipped with a
3-pin plug which mates with 3-pin wall outlets to minimize the possibility of electrical
shock. Do not under any circumstances cut or remove the ground wire from the power
cord supplied.
Use of extension cords is not recommended.
To prevent accidental injury, secure the cord behind the Buffet Chiller so that it is not left
exposed or dangling.
4