Summit TCL73XNAADA - Manual (Page 6)

6
EN
Start and Programs
Choosing a program
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type ( see
Laundry ).
3. Open the door and make sure the filter is clean
and in place and the water container is empty and
in place (
see Maintenance ).
4. Load the machine and make sure that the items
are not in the way of the door seal. Close the door.
5. If none of the lights are on: Press the On/Off
button .
6. Choose a program by checking the Programs guide
(
see Programs ) as well as the indications for each
type of fabric ( see Laundry ).
- Select a program by rotating the PROGRAMS knob.
7. Set a delay time and other options if necessary.
8. The Start/Pause light is flashing green, press the
Start/Pause button to begin. The green light
stops flashing.
During the drying program, you can check on
your laundry and take out the items that are dry
while others continue drying. When you close
the door again, press the Start/Pause button
in order to resume drying.
(
When the door is open the Start/Pause light will
flash amber and after the door is closed and the
Start/Pause button pressed will stop flashing and
show green
).
9. During the last few minutes of Drying Programs,
before the program is completed, the final Cool
Tumble phase is entered (fabrics are cooled), this
phase should always be allowed to complete.
10. The buzzer (alert) will warn you when the program is
complete. Open the door, take your laundry out.
Clean the filter and replace it and empty the water
container and replace it (
see Maintenance ).
If the Post Care Option has been selected and
you do not take the clothes out immediately, the
clothes will tumble occasionally for 10 hours or
until you open the door.
11. Unplug the dryer.
Note : This tumble dryer is fitted with an automatic standby system which is enabled after about 30 minutes if no
activity is detected. Press the ON-OFF button briefly and wait for the machine to start up again.
Easy Iron Program (15)
Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minute Cool Tumble period) which
fluffs the fibers of clothing that have been left in the same position/location for an extended period of time. The
cycle relaxes the fibers and makes them easier to iron and fold.
!
Easy Iron is not a drying program and should not be used for wet articles of clothing.
For best results:
1.
Do not load more than the maximum capacity.
These numbers refer to the dry weight:
Fabric Maximum load
Regular Cotton and Regular Cotton mix 5.5 lb / 2.5 kg
Permanent Press 4 lb / 2 kg
Denim 4 lb / 2 kg
2. Unload the dryer immediately after the end of the program, hang, fold or iron the articles and put them away.
Should this not be possible, repeat the program.
The Easy Iron effect varies from one fabric to the next. It works very well on traditional fabrics like Regular
Cottons or Regular Cotton mix, and less well on acrylic fibers.
Wool Program (13)
●
This is a program for tumble dryer safe garments marked with the symbol .
● It can be used for load sizes up to 2 lb / 1 kg (approximately 3 sweaters).
●
We recommend that garments are turned inside out before drying.
● This program will take about 60 minutes, but may take longer depending on the size and density of the load
and the spin speed used in your washer.
● Loads dried using this program are usually ready to wear, but on some heavier garments the edges may be
slightly damp. Allow these to dry naturally as over-drying could damage garments.
! Unlike other materials, the mechanism of wool shrinkage is irreversible; i.e. it will not stretch back to
original size and shape.
!
This programme is not suitable for Acrylic garments.