SPYPOINT IRB-W-B - Manual (Page 5)

9 8
English
English
ALKALINE BATTERIES
IR-Booster
The IRB-W/IRB-W-B are powered by 4 D batteries
(1.5V), not included. To install the batteries, open
the cover on bottom side of the IRB-W/IRB-W-B.
Insert batteries as indicated, battery polarity must be
followed (+ and -).
Transmitter
The transmitter is powered by 2 AAA batteries (1.5V),
not included. To install batteries, turn the strap clip
and pull battery cover upwards. Insert batteries as
indicated in the battery compartment, battery polarity
must be followed (+ and -).
WIR ELESS
P INT SPY TM INT P SPY
D
+
D
+
D
+
D
+
POWER
BATTERY LEVEL
It is possible to know the battery level of the IRB-W/IRB-W-B and the
wireless transmitter when turned on. The battery life indicator will be on for
a period of 8 seconds when the batteries are full. When the indicator blinks
for 8 seconds, the batteries are low and need to be replaced. If the indicator
remains off, the batteries are completely empty or are possibly installed in the
wrong polarity (+ and -).
Tip: At each visit to the installation site of IRB-W/IRB-W-B and wireless
transmitter, make sure to verify the level of your batteries by doing the ON/
OFF procedure.
Note: The use of 50 or 100 LED mode has a direct influence on the energy
supplied by the batteries (50 LED is more efficient than 100 LED) and
therefore on the operation autonomy
of the IRB-W/IRB-W-B.