SPYPOINT FL-8 - Manual (Page 4)

6 7
English
English
POWER
The battery level is shown in the lower left corner of the LCD
screen. When a single line remains, the camera will continue to take
pictures but we strongly recommend changing the batteries before
they are empty. (See figure below)
AA BATTERIES
This camera requires the use of 6 AA batteries (1.5V). The use of
alkaline or lithium batteries is strongly recommended. Also note
that the voltage of rechargeable AA batteries (1.2V) is insufficient
to power this camera. During the installation of the AA batteries,
slide the switch inside the battery case to ALK (i.e. alkaline). Insert
the batteries as indicated inside the battery case. Exact polarity must
be followed. We also recommend the use of new batteries to ensure
maximum performance of your camera.
LITHIUM BATTERY PACK
The camera can be powered by a rechargeable lithium battery pack
LIT-09/LIT-C-8 (sold separately, see section OPTIONS). This type
of battery is less affected by cold temperatures and lasts up to 3
times longer than an alkaline battery. During the installation of
the lithium battery pack, slide the switch inside the battery case to
RECH
.
EXTERNAL (12V)
The camera can also be powered from an external 12-volt DC input
such as a 12-volt battery (KIT-12V/BATT-12V, sold separately) or a
12V adapter (AD-12V, sold separately). During the installation of a
12V connection, place the switch inside the battery case to ALK (the
AA batteries can remain safely inside the camera). If combined with
a lithium battery pack, slide the switch to RECH. For the accessories
available, see section OPTIONS.
SOLAR PANEL
This model also offers the possibility of a connection to a solar
panel SP-12V (sold separately, see section OPTIONS) to maintain
the charge of the lithium battery pack LIT-09/LIT-C-8 (sold
separately, see section OPTIONS). During the installation of the
rechargeable lithium battery pack, slide the switch inside the battery
case to RECH to activate the charging system of the solar panel.
Power source Switch position
• 6 AA
• 12V
• 12V + 6 AA
ALK
• LIT-09
• 12V + LIT-09
• Solar Panel + LIT-09
RECH
MEMORY STORAGE
Using a memory card (sold separately, see section OPTIONS) is
required to operate the camera. When the camera is ON and no
memory card is used, the LCD screen displays "CArd" meaning to
insert one.
The camera is compatible with SD/SDHC memory
card, up to 32 GB capacity. Before inserting or removing a
memory card, the camera must be turned off. Failing to do
so may cause loss of pictures or damage the pictures already
saved on the memory card.
When the SD card is full, the LCD
screen indicates "FUL". The following data shows an approximate
quantity of photos which can be recorded by the camera depending
on the memory card capacity.
RESOLUTION 2.0 GB 4.0 GB 8.0 GB 32 GB
3 MP
8 MP
2000
1200
4100
2400
8200
4800
32800
19000
VIDEO RESOLUTION
320 x 240
640 x 480
2h
65 min
4h
2h10
8h
4h10
32h
16h40
"BUSY" LED
The "BUSY" light, located next to the screen, lights up when the
camera is recording
.