Spaulding Lighting Laredo LMC HID - Manual (Page 2)

STEP V LAMPING
• Make sure that the lamp size and type matches the ballast
specifications.
• Replace reflector (H).
• Engage the lamp to socket (S).
• For medium base lamps – to ensure proper contact, loosen
the lamp one turn then retighten.
STEP VI RE-LAMPING USING POLE STICK (By others)
(See Fig.4)
CAUTION:
WEAR SAFETY GOGGLES IN THE EVENT LAMP BREAKS
• Using the other end of the pole, push latch pin (D) and
slowly lower the door to open position.
• Align lamp changer (U) with the lamp, then slowly push up
to engage. Unscrew to remove lamp.
• Attach the replacement lamp to head changer (U), align
with the socket and screw in to engage.
• To close door use again the other end of the pole, raise the
front end of the door up to engage latch.
REMOVING FRONT DIRECTOR FOR IMPROVING
FORWARD THROW BEAM DISTRIBUTION.
• Loosen (4) retaining screws (X) and remove reflector (H).
• Unbend the two tabs to remove the front director (Z).
STEP VII INSTALLING VANDAL SHIELD (See Fig. 5)
• Open door (E) by loosening retaining screws (F).
• From the inside on each (4) bosses adjacent to the lens
clips, drill the door through using .173” diameter No.17 drill
bit.
• Install vandal shield (Y) using (4) self-threading screws (V)
provided.
• Remove metal chips and replace door.
STEP VIII PBT PHOTOCONTROL FIELD INSTALLATION
(See Fig. 6)
• Remove hole plug (N) from the side of housing.
• Install photocontrol switch (PC) from the inside of housing
using gasket (gg) and nut (nn).
PT. NO. 93002010
Outdoor Lighting
laredo
INSTALLATION INSTRUCTIONS FOR WALLPACK LUMINAIRE