Spaulding Lighting RAVEN SERIES - Manual (Page 2)

HOW TO SERVICE THE BALLAST TRAY (RCS SERIES) HOW TO SERVICE THE BALLAST TRAY (RCL SERIES)
2
OPEN
(OPTIONAL)
FIG. 8
BALLAST
REINFORCING PLATE
TRAY
HOOK
VANDAL SHIELD INSTALLATION
RETAINING
SCREWS
CONNECTOR
FIG. 6
(OPTIONAL)
PEEL OFF
PAPER
FLAT WASHER
NUT
POLYCARBONATE
SCREW
SHIELD
SUPPORT
LENS
BRACKET
FIG. 9
CONNECTOR
(OPTIONAL)
SCREWS
RETAINING
(BY OTHERS)
WIRES
INSTALLATION
CONNECTOR
FIG. 7
LUMINAIRE TO ARM
DOOR
LATCH PIN
SUPPLY
Do not leave receptacle open to the elements.
a photocontrol or shorting cap in place.
NOTE: The luminaire will not operate without
THREADED RODS
ADJUSTING PHOTOCONTROL SWITCH
PHOTOCONTROL
SUPPLY
WIRES
NOTE: SUPPLY VOLTAGE MUST MATCH BALLAST
KNOT
INSIDE HOUSING WIREWAY
FIG. 5
WIRE TIE
ARM
GROUND WIRE
DOOR FRAME
SCREW
LUMINAIRE
HOUSING
FIG. 4
FIBERGLASS PAD
(SELECT UNITS)
LAMP SUPPORT
FIG. 3
COMPRESSION RING
RECEPTACLE
SCREW
LOCKWASHER
FLAT WASHER
NUT
ARM
POLE
COVER
(OPTIONAL)
NORTH
SWITCH
ORIENT ARROW
PHOTOCONTROL
OPTIONAL
QTZ RELAY
FUSEBLOCK
STARTER