Spaulding Lighting Cimarron CR1 - Manual (Page 3)

CURVED ARM MOUNT
NOTE: Fixture weight is approximately 60 pounds.
HOUSING (4-HOLE
E. WALL MOUNT INSTALLATION (FIGURE 3 AND 4)
(PATTERN END)
FIGURE 5
DRILL (4) HOLES
HOUSING (4-HOLE
(PATTERN END)
TO
(PATTERN END)
HOUSING (3-HOLE
TO
ARM
CURVED WALL MOUNT
FIGURE 4
J-BOX
DRILL
(4) HOLES
WALL MOUNT
FIGURE 3
J-BOX
TEMPLATE
TEMPLATE
H
IN PLACE. DO NOT LEAVE RECEPTACLE OPEN TO
A PHOTOCONTROL SWITCH OR A SHORTING CAP
NOTE: THE LIGHT WILL NOT OPERATE WITHOUT
THE ELEMENTS.
J. LUMINAIRE INSTALLATION TO CURVE ARM (FIGURE 5)
M. PHOTOCONTROL SWITCH (FIGURE 8)
L. VANDAL SHIELD INSTALLATION TO FLAT
PERFORMED BY A QUALIFIED ELECTRICIAN.)
K. WIRING: POWER MUST BE OFF. (WIRING MUST BE
GLASS UNIT (FIGURE 7)
INSIDE BALLAST AREA
FIGURE 8
PHOTO CONTROL
CONTACT
PAPER
NORTH
VANDAL SHIELD
FIGURE 7
KNOT
NOTE: SUPPLY VOLTAGE MUST
MATCH BALLAST
SUPPLY
WIRES
WIRE
TIE
GRN
U
TRAY REMOVED
FIGURE 6
HEX NUT
LOCKWASHER
FLAT WASHER
CAST WALL BRACKET
HOLE PLUG
CAST ARM
SCREW
COVER
HEX NUT
LOCKWASHER
FLAT WASHER
CAST WALL BRACKET
HOLE PLUG
GASKET
THREADED ROD
RETAINER WASHER
LOCKWASHER
HEX BOLT
FLAT WASHER
COVER
SCREW
CAST ARM
GASKET
POLE COVER POLE COVER
CAST ADPTOR
ROUND POLE
NUT PLATE
NUT PLATE
FLAT WASHER
HEX BOLT
LOCKWASHER
FLATWASHER
TUBULAR SPACER
SCREW
FLATWASHER
POLYCARBONATE
SHIELD
PHOTOCONTROL
SCREW
RECEPTACLE
SQUARE AND ROUND POLES
** SECURE SUPPLY WIRES TO NYLON TIE DOWN
268-1300-9901 CIMARRON INSTALLATION INSTRUCTIONS (PG 3/3)
SAVE THESE INSTRUCTIONS
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000 www.spaulding-ltg.com