Sensaphone IMS-1000 Upgrade instructions - Manual (Page 2)

2 IMS-1000 Software Update Notice
IMS-1000 Embedded Firmware Feature and Correction Summary
Version 1.5.67.217 (May 1, 2013)
• Corrected an issue which sometimes caused a voice call to disconnect unexpectedly.
Version 1.4.155.28 (November 12, 2012)
• Added software support for newer serial flash chips.
Version 1.4.65.29 (April 26, 2012)
• Corrected fax and alpha-pager alarm message to use the “last alarm” value instead of the current
time.
• Corrected usage of alphanumeric paging passwords in the destination string.
• Updated the firmware download link on the Advanced Configuration page.
• Added the Alarm Hold Time parameter to environmental inputs.
Version 1.3.167.250 (October 25, 2011)
• Enhanced the performance of the History export function.
• Removed SNMP, SNMP-Trap, and IRC from the IP Alarm menu.
Version 1.2.133.177 (August 25, 2010)
• Improved the processing of camera snapshots sent via e-mail
• Improved the error messages related to camera snapshots
Version 1.2.112.228 (July 20, 2010)
• Updated kernel to support updated Intel/Numonyx flash memory chip. Previous firmware
versions will not allow flash updating if newer flash memory chip is installed. In this case, factory
reprogramming is required.
• Improved Alarm Response camera routines.
Version 1.2.47.146 (March 26, 2010)
• Running a flash update will now delete files to ensure that there is enough room on the file system
to upload, extract, and complete the system update.
• Must be running firmware version 1.0.115.151 or greater before you can install this update (see
instructions).
Version 1.2.4.49 (January 15, 2010)
• Corrected an issue which caused a delay in the delivery of subsequent alarms whenever a prior
alarm was acknowledged on a voice call.
• Must be running firmware version 1.0.115.151 or greater before you can install this update (see
instructions).
Version 1.1.123.140 (August 17, 2009)
• Corrected an issue affecting IP Alarms where the IP Alarm process could potentially fail to detect
the presence of a valid network device.
• Must be running firmware version 1.0.115.151 or greater before you can install this update (see
instructions).
Version 1.1.38.113 (March 9, 2009)
• Corrected issue when alarms would reactivate due to expired reset time. Only affected e-mail
delivery.
• Must be running firmware version 1.0.115.151 or greater before you can install this update (see
instructions).