SciGene NoZone WS Enclosure User Manual
Page 2
Page 2
SciGene • 617 N. Mary Avenue, Sunnyvale, CA 94085 •
• Version 1.1, July 2010
» Step 1. Position Back Panel for Assembly
Note: The enclosure is assembled in an unusual orientation with the back panel facing down on the
assembly surface and the door facing toward the ceiling. Once assembled, the enclosure is lifted and
rotated to its correct orientation.
Place the Back Panel face down on a table or other flat surface. Note which edge has a black gasket.
» Step 2. Attach Top Panel
Attach the Top Panel to the Back Panel frame making certain to attach to the Back Panel edge that
does not have a black gasket. Seat the acrylic panel into the channel in the bottom frame using the
rubber mallet. Place fasteners flush with the frame. Use Hex Wrench to tighten fasteners by placing it
into the groove of the frame.