Schwank TruTemp IR Setback Thermostat - Manual (Page 3)

TruTemp Manual
IM080326
RD: Aug 2006
RL: 3C
KH
1. Control should be located away from direct
radiant heat (also consider other sources of
radiant heat such as sunlight, machinery,
etc.). However the control should be able to
'see' the same conditions that the
occupants will be experience.
2. Install a 4" octagon or a 4" pancake electrical
box where control will be located (strongly
recommended but not required). Position
fixture mounting screws of electrical box
horizontally.
3. Run 18/3 thermostat cable from the heater
relay to the electrical box. For cable runs
over 50' use 16/3 cable. For cable runs over
100' use 14/3 cable. Call factory for any
cable runs 150' or over. See wiring diagrams
for appropriate installation.
4. Connect cable to electrical box leaving 8"
of cable hanging out.
5. Strip outer sheathing off the 8" of cable
protruding from box.
1