Schwank IEP-1524 - Manual (Page 17)

17
IM110810
RD: AUGUST 2011
RL; 1A
BA
InfraSave IEP-1524 Manual
Heat Lamp Replacement :
… continued
Step 9
Remove end plate from heater: 6 Phillips screws fasten
the heater body end plate in place.
Step 10
Slide cover plates and heater mounting bracket out from
top side of heater.
Remove remaining end plate from other end of heater.
Step 11
Slide Face Plate out from each end of heater.
Step 12
Remove the heat lamp retainer clip at each end of lamp.
Step 13
IMPORTANT: Wear gloves to handle the heat lamp.
Oils from your skin will damage the lamp.
The heat lamp is fragile! Carefully side old heat lamp out
of heater through rectangular slot in end of reflector.
Carefully install new heat lamp and clip in place.
Reverse steps above to reassemble the heater.