S&S Cycle Stealth Air Cleaner Kit for 1993 and Up Stock CV Carburetor and 2001 and Up Stock Delphi EFI - Manual (Page 4)

4
8- Check between the cylinder head and the backplate for air gaps.
NOTE: A feeler gauge works well for determining the amount of gap, if any, between the head and the backplate as illustrated in Picture 6.
9- If a gap less than the thickness of a rubber coated washer is present, torque the breather bolts down 10 -12 ft.-lbs. If a gap of more than the
thickness of a rubber coated washer is present, determine how much and select the appropriate number of rubber coated washers needed to
take up the gap.
10- If more than one rubber coated washer is needed between the head and backplate, back out the breather bolts and install the correct number
of rubber coated washers.
11- Thread the breather bolts in and finish torque breather bolts to 10-12 ft.-lbs.
12- Locate the filter, plastic filter top plate and the two ¼" X 20 flanged head fasteners as illustrated in Picture 7.
13- Apply a drop of 243 blue Loctite® to the threads of each ¼" X 20 flanged head screw and set aside.
Picture 7
Filter Top Plate
Filter Flanged Head Screws
Picture 6