S&S Cycle EZFI-C - Manual (Page 3)

3
9- Insert the five EZFI-C™ wires into the ECM connector per Table 3 and confirm that all the wiring matches the wiring diagram in Figure 1.
10- Install the clear retainer onto the ECM connector and close the connector. Use a zip tie for strain relief of the ECM connector wires. Reconnect
the harness to the ECM.
11- Reconnect the negative battery cable and black EZFI-C wire to the negative battery terminal. If the EZFI-C’s ground lug will not reach the
battery, bolt it to a suitable grounding point on the frame.
12- Reinstall the electrical caddy (Harley Davidson® Dyna® installation only), side covers and seat.
Table 3 EZFI-C Wire Colors in ECM Connector
EZFI-C Wire Color ECM Pin #
Blue 3
White 13
Red 19
Orange 21
Violet 24
Figure 1