S&S Cycle Custom Connector Kit for the S&S EFI Wire Harness - Manual (Page 2)

2
The safety of the motorcycle rider is dependent on proper installation of this product. If you are not certain of your capabilities or do
•
not have the correct tools for this installation, please consult a shop to have it done for you. Improper installation of this product could
result in injury or death to the rider.
Ensure that the battery has not been connected, and do not connect the battery until told to do so in these instructions. Failure to do so
•
may result in damage to your wire harness and other motorcycle electronics which can result in costly repair and service fees. With the
battery also remaining disconnected during the entirety of this installation prevents accidental starting of the motorcycle which could
cause injury to you or others around you.
To avoid damage to motorcycle and motorcycle components follow the guidelines specified by the manufacturer when assembling and
servicing your motorcycle.
When S&S® released the X-Wedge™ engine, this created an additional market to provide the customer with a complete wiring harness for custom
motorcycles. The S&S EFI wire harness was created specifically for motorcycle frames with two inches of stretch in the backbone and using fuel
injected S&S engines, including X-Wedge. The S&S EFI wire harness also accepts most stock parts designed to fit Harley Davidson® Softail® models
along with other parts specifically offered through S&S. In order to get those components to fit, the S&S custom connector kit contains all the
necessary connectors that will allow you to meet your electrical needs. With connectors that directly mate to the S&S EFI wire harness, we’ve
eliminated the guess work of determining what you’ll need to get your fuel injected bike on the road.
NOTE: The S&S EFI Wire Harness is only compatible with motorcycles utilizing Delphi® style modules such as S&S USB Delphi style VFI Module #55-5090
for 2001 Softails® and all 2002-’07 models or a Harley-Davidson equivalent module if used in non X-Wedge applications.
Kit Contents (Not all quantities of components listed below are shown in Picture 1)
• Left Hand Control Connector (1)
• Fuel Gauge Connector (1) • Front Turn Signals Connector (1)
• Right Hand Control Connector (1) • Indicator Lights Connector (1) • Sealing Plugs (10)
• Headlight Connector (1) • Speedometer Connector (1) • DT Terminal Pins (10)
• DT Terminal Sockets (20) • DTM Terminal Pins (23) • DTM Terminal Sockets (12)
Tool Requirements
• Deutsch® Crimper DTT-16-00 or equivalent
• Deutsch® Crimper DTT-20-00 or equivalent
• Wire Stripper
• Zip ties
Variable Fuel Injection (VFI) requires training and certification to work on it properly. S&S® strongly recommends you take your motorcycle
to an S&S® certified VFI center for any VFI or Closed Loop Variable Fuel Injection (CLVFI) modifications.
CAUTION
WARNING
Picture 1
CAUTION