S&S Cycle VFI Knock Sensor Kit for 2001-07 Delphi Style VFI Module (with USB) - Manual (Page 3)

3
Picture 1
Picture 2 Picture 3
a. Knock sensor mounting at Location 1:
Rear cylinder head
1. Remove the plug from the rear head (if present).
2. Insert the 5/16 x 11/2" coarse thread bolt (f) through the 5/16" lock washer (g), knock sensor (a), and 1/4" thick spacer (b).
3. Apply Loctite® (i) to end of the bolt and attach the assembly to the rear head. Torque to 11 ft-lb. See Picture 1.
b. Knock sensor mounting at Location 2:
Top motor mount location.
1. Remove the rear motor mount bolt from the rear cylinder head. See Picture 2.
2. Test fit the knock sensor mounting block (c) to the rear motor mount location using the 3/8" x 2" coarse thread bolt (d) and 3/8" lock
washer (h). Test fit the knock sensor to mounting block using bolt (e) and lock washer (g). See Picture 3.
CAUTION
Carefully place the fuel tank back into position to check the knock sensor and mounting block clearance. Position the mounting block
so that the knock sensor or mounting block does not contact the fuel fitting or any other part of the motorcycle. If the wiring harness or
outer body of the knock sensor (black plastic portion) contacts the engine or any other part of the motorcycle, it could damage the knock
sensor, or interfere with its ability to detect knock.