S&S Cycle VFI Cruise Control Adapter Kits - Manual (Page 4)

14. Use included cable ties to secure cable as
required.
15. Cycle completed cruise control arm and cable
assembly through its entire range of travel.
Ensure there is no binding, and a minimum of
1 /
8
" clearance on all moving parts.
16. Replace gas tank per appropriate service
manual.
D. Cruise Control Adjustment
1. Adjust cruise control and throttle cables per
the appropriate service manual. Installation of
the S&S
® cruise control adapter does not alter
the factory cruise control adjustment
procedure.
E. Troubleshooting
The most common cruise control problems are cable
adjustment related.
1. If cruise control cable is adjusted too tight, it
may cause the following:
a. Motorcycle will gain 1-2 mph when RES/SET
switch is pressed down to "set" speed.
b. Cruise cable will pull throttle spool off of
idle and prevent setting idle speed.
2. If cruise control cable is set too loose, it may
cause the following:
a. Motorcycle will lose 1-2 mph when RES/SET
switch is pressed down to "set" speed.
NOTE - For more detailed troubleshooting, refer to the
appropriate service manual.
12. Install the clip on the end of the cable ferrule.
Use a small telescoping magnet to position the
retaining ring from below, then use a pick or
small screwdriver to push it into the groove
from above. See Picture 5.
Ensure that clip is fully seated in groove.
13. Install cruise control cable end onto cruise
control arm according to either "a" or "b"
below.
a. For 1993-'97 models with a metal ring on
the cable end: Place the ring over the pin on
the end of the cruise control arm and
secure with the included clip.
Ensure that clip is fully seated in groove.
b. For 1998-up models with a plastic retaining
cap on the cable end: Snap plastic cap over
the T-head pin on the end of the cruise
control arm. See Picture 6.
Picture 6
Cable Placement on Cruise Control Arm
(1998-up Shown)
CAUTION
CAUTION
Because every industry has a leader